1000 Axial cyclones sold in Q1
Customers in the UK, USA, Russia and Italy have placed several orders this year for our Highspeed Axial Swirltubes for a variety of applications. Most orders are for stainless steel units, but a number are being supplied in GFP as a cost effective alternative.
The Cyclones are frequently used where very high gas loads mean that alternative mist eliminators require too much area and hence large pressure vessel diameters.
4100mm Diameter KWM Mist Eliminator for Bangladesh
This KWM-B1 mist eliminator was manufactured and shipped in November 2014 to a customer in Bangladesh for service in a fertilizer complex. Manufactured in SS316L, the unit measured 4100mm diameter x 150mm thick, plus top and bottom grids.
See us at ADIPEC 2014
Visit us this year on Stand 11450 together with our regional partners Finepac, where our full range of K-SEP separator internals and cyclones will be on display. We will also be demonstrating our SEP-Calc design software.
New award announced for plate packs…
KIRK process was pleased to recently be awarded a contract to supply a significant quantity of plate pack coalescers for a large production separator located at an onshore UK oilfield. The KFP-A packs are designed to be low fouling and to reduce the oil content of a produced water stream.
Liquid-Liquid Coalescers for FPSO
A combination of our KMP Matrix Packs and KDM Dual Media Mesh (pictured) was recently used by a customer in Asia on a FPSO development to separate produced water from condensate within two horizontal, liquid filled vessels. The matrix pack achieves the initial coarse separation and liquid distribution in the same stage, whilst in the second, polishing stage final removal down to 100ppm or better is achieved using the co-knitted filament pad. A variety of matrix pack and dual media pad styles are available to suit the various applications and fluid properties. Contact us for more information.
Large KVID’s and Vane Packs Delivered
KIRK Process has just completed a project for an end user in Russia. The contract included various large multi-vane inlet diffusers and 4-bank pocketed vane packs as shown here, to be installed in natural gas pipeline compressor KO drums.
KIRK at ADIPEC 2013
K-SEP Separator Internals
A lot of interest was shown at this year’s ADIPEC exhibition for KIRK’s K-SEP range of separator internals. Also on display was our new multicyclone bundle for gas/liquid/solids separation, featuring removable cyclone tubes.
KIRK takes bookings for 1000 axial cyclones…
It has been a busy summer this year with orders being taken from regular and new customers for our Highspeed axial cyclone swirl tubes, both in stainless steel and glass filled polyamide. These are being assembled at our new works where we keep higher levels of parts in stock allowing much quicker delivery times than before.
Large Inlet Cyclone Cluster for Mexico
Defoaming Inlet Cyclone Cluster Design for SEPCO Inc
Working with our partners Sepco Process Inc. of Houston, we recently designed the inlet defoaming cyclone device for a large 3 phase separator. This was manufactured in 1 piece for installation before the vessel closing head was welded. The pictures show the high flow diffuser design for the liquid outlet.
KPSL Expands into New Premises
To cater for increased production and storage, KIRK Process Solutions Limited has acquired new premises including warehousing and assembly lines for the Highspeed Cyclones, as well as new offices above.
Stock levels will be increased by this expansion, allowing shorter lead times to be achieved once the facility reaches full production early in 2013.
Unit 2 Pool Close, West Molesey, Surrey KT8 2HW